d398a6ced2
- CitrineOS core extracted (CSMS OCPP 2.0.1) - OpenOCPP extracted (firmware OCPP 1.6J/2.0.1) - ShapeShifter library installed (pip install -e) - ShapeShifter specification extracted - EVerest extracted TODO updated with progress
51 lines
1.6 KiB
YAML
51 lines
1.6 KiB
YAML
description: Driver module for the YETI hardware v1.0
|
|
config:
|
|
serial_port:
|
|
description: Serial port the Yeti hardware is connected to
|
|
type: string
|
|
default: /dev/ttyUSB0
|
|
baud_rate:
|
|
description: Serial baud rate to use when communicating with Yeti hardware
|
|
type: integer
|
|
minimum: 9600
|
|
maximum: 230400
|
|
default: 115200
|
|
reset_gpio_chip:
|
|
description: >-
|
|
Reset GPIO chip to use to HW reset Yeti. If set to empty string, it is disabled.
|
|
type: string
|
|
default: 'gpiochip0'
|
|
reset_gpio:
|
|
description: GPIO line to use to reset Yeti
|
|
type: integer
|
|
default: 27
|
|
caps_min_current_A:
|
|
description: Minimal current on AC side. For AC this is typically 6, but for HLC this can be less. -1 means use limit reported by HW.
|
|
type: integer
|
|
default: -1
|
|
caps_max_current_A:
|
|
description: Maximum current on AC side. For AC this is typically 16 or 32, but for HLC this can be less. -1 means use limit reported by HW.
|
|
type: integer
|
|
default: -1
|
|
provides:
|
|
powermeter:
|
|
interface: powermeter
|
|
description: provides the Yeti Internal Power Meter
|
|
board_support:
|
|
interface: evse_board_support
|
|
description: provides the board support Interface to low level control control pilot, relais, motor lock
|
|
rcd:
|
|
interface: ac_rcd
|
|
description: RCD interface of the onboard RCD
|
|
connector_lock:
|
|
interface: connector_lock
|
|
description: Interface for the motor lock
|
|
enable_telemetry: true
|
|
metadata:
|
|
license: https://opensource.org/licenses/Apache-2.0
|
|
authors:
|
|
- Cornelius Claussen
|
|
- Kai-Uwe Hermann
|
|
- Thilo Molitor
|
|
- Anton Wöllert
|